1, non-standard precision parts processing factor is the poor machining accuracy of the parts themselves. Generally speaking, if the dynamic error between the shafts is not adjusted during installation, or if the shaft drive chain changes due to wear, it will affect the precision of the parts. Generally, the accuracy check caused by this error can be solved by readjusting the compensation amount. If the error is too large or even an alarm occurs, the servo motor needs to be checked to see if its speed is too high.
2, the factor is the amount of overshoot in the operation of the machine tool will also affect the machining accuracy. It may be that the acceleration and deceleration time is too short. Properly extend the replacement time. Of course, it is also likely that the link between the screw and servo motor is loose....
3, the factor is that the two-axis linkage generated by the roundness of the overshoot, improper adjustment of the machine, the formation of circular axial deformation, axis screw gap compensation is not correct or axis positioning offset, may affect the precision of precision parts. Produce impact.