A few points for attention in the processing and grinding of small batches of non-standard parts are as follows: let's take a look at the manufacturers of small batches of non-standard parts. 1. The abrasive grain size used for processing and grinding small batch of non-standard parts shall be changed from coarse to fine. When replacing the abrasive, the grinding trace of the previous process should be completely removed, and the grinding should be stopped until only the grinding trace of this time can be seen. It is very important to avoid the phenomenon of "embossing". 2. The same abrasive can only be used in the processing of small batches of non-standard parts with the same abrasive size. Before each particle size conversion, the workpiece must be completely cleaned once to prevent the coarser abrasive particles or other dirt from being brought to the next process to form scratches on the grinding surface. 3. During the processing of small batch of non-standard parts, each time when the next grain size is converted, the grinding shall be conducted at an angle of 30-45 ° with the last grinding direction. If there is a deep scar, it is not allowed to grind this part only, otherwise this part will be pitted. It is required to conduct a comprehensive repair to remove the pit. For the stations that are easy to grind and those that are not easy to grind, attention should be paid to uniform grinding. The above articles are shared by small batch non-standard parts processing manufacturers today. Do you understand them?
