Today, with the rapid development in the market in various industries, recognized by everyone as well as the use of this is proof of the existence of this industry, is how important, when we do not come into contact with this industry, it is certainly not a certain understanding of it, then the precision machining in the techniques and tricks are what?
Trick one: the vise jaws removed, another processing two M4 threaded holes, two flush with the jaws of 1.5mm thick steel plate 2, with aluminum buried rivets riveted on 0.8mm thick hard brass plate 3 will be fastened to the jaws with M4 buried screws 1, constituting a durable soft jaws. This can also maintain the hardware parts are not clamped bad, but also has interchangeability.
Trick two: using magnets to draw small parts (fee pieces) sucking and taking are not convenient, can suck an iron plate 2 under the magnet 1, not only can suck a lot of small pieces, and the iron plate will be pulled away, small parts will immediately automatically dumped into the collection box, lack of moving heart, but very applicable.
Trick three: the pulley drive, the pulley often slipped between the axle, the axle with ￠ 15 ~ 18mm scratch nest drill bit to scratch a series of nest, which can constitute the adsorption force to avoid slippage, turning waste into treasure, the boss will reward.
Tip 4: When the hexagonal wrench 1 shank is short and cannot be forceful, the tube with a slightly larger inner diameter than the wrench can be inserted into the slot from a section of the milling slot, which can be used as a long shank.
Tip 5: There is the saying of positioning and then clamping about tightening the workpiece, but about a workpiece, the first clamping and then positioning, because the clamping will certainly try to deform the workpiece, so it should be clamping and then positioning, about the 6-point positioning, looking to limit its freedom.
