Send Message
Up to 5 files, each 10M size is supported. OK
Shenzhen Perfect Precision Product Co., Ltd. 86-189-26459278 lyn@7-swords.com
News Get a Quote
Home - News - What are the common problems of lathe parts?

What are the common problems of lathe parts?

November 30, 2022

Common problems and causes of lathe parts processing are detailed as follows:
1. Burr: During stamping or trimming, there is no residual material, and burr will occur under the section of steel plate. Cross sections are used for reference. When
When the height of burr is more than 0.2mm, burr will occur. Iron powder will damage the mold and produce bumps.
2. Concave and concave: The surface of the material is abnormally convex or concave, which is caused by the incorporation of foreign matters (iron filings, dust).
3. Drum printing: the cleaning roller or the paper feeding roller is caused by the attachment of foreign matters (at a fixed interval). Normally, you can clear the print in the Foreign matter on the paper.

latest company news about What are the common problems of lathe parts?  0
4. Sliding printing: occurs when the roller slides, stops suddenly or accelerates.
5. Crushing of coiled material may wrinkle at the edge: the guide roller of uncoiling line may be the gap between the guide rollers on the mold due to unwinding of the mold feed port It is caused by wrinkling.
6. Scratches: the main cause of scratches on parts. There are sharp scratches or metal dust falling into the mold. The preventive measure is to repair the Scratch and remove metal dust.

latest company news about What are the common problems of lathe parts?  1
7. Bottom crack: The main reason for the bottom crack of this part is that the material is poor plasticizing or pressed too tightly on the mold compression ring. The preventive measures are more
Replace the plastic or loosen the presser foot ring.
8. The sidewall has wrinkles: the main reason for the sidewall of the part to have wrinkles is that the thickness of the material is not enough (less than the minimum allowable thickness), or when the upper part
The lower die is installed when the material at the lower part is eccentric, so that a large gap is generated at one side. The clearance is very small. The preventive measure is to replace the material
And readjust the die.

latest company news about What are the common problems of lathe parts?  2