Before each CNC precision part processing program, it is required to strictly determine whether the tool is consistent with the program. It is necessary to determine the length of the tool and whether the tool clamping blade is suitable for cutting. It is strictly forbidden to start the door to prevent darts or workpiece flying during the machine tool operation. In the whole process of CNC precision parts processing, if the operator finds the knife collision, he must park the car immediately, such as pressing the "Emergency Termination" button or the "Reset Switch" button or setting the "Feed Rate" to zero.
Each tool setting in the same workpiece shall be kept in the same area to ensure the accuracy of the tool when receiving the tool. In the whole process of CNC precision parts processing, if it is found that there is too much machining surplus, it is necessary to use "single section" or "stop" to clear the X, Y, Z mark values, and then manually mill them off, and then shake them back to "zero" to allow them to operate independently. During the autonomous operation, the operator shall not leave the machine tool or inquire about the management of the machine tool on time. If it is necessary to leave halfway, it must be checked by specific staff.
Clean up the aluminum slag in the machine tool before spraying oil with the light knife to prevent the aluminum slag from degreasing. Blow with air as much as possible in the roughening procedure, and inject oil in the light knife procedure. The workpiece shall be removed, ground and polished immediately after it is unloaded at a high speed. At the time of off duty, the operator must do a good job of immediate and accurate work handover to ensure that all subsequent production and processing can be carried out normally. Before standby, make sure that the tool magazine system is at the initial position and XYZ axis is stopped at the center position. Turn off the power supply and the main power supply on the machine tool operation panel successively. In case of thunderstorm, be sure to disconnect the power supply and stop working immediately.
