Analysis of CNC Precision Machining Plant on Machining Route of Groove
Shenzhen CNC Precision Processing Factory can directly cut into the groove with the same width as the groove for the groove with relatively small width and depth values and low precision requirements. After the cutter cuts to the bottom of the groove, the delay command can be used to make the cutter stay for a short time to trim the roundness of the groove bottom. In the exit process, the working speed can be used.
For deep groove parts with small width value but large depth value, in order to avoid the phenomenon that the front pressure of the tool is too large and the tool is broken due to the poor chip removal during the cutting process, the method of staged feed should be adopted. After the tool cuts into the workpiece at a certain depth, it should stop feeding and back a distance to achieve the purpose of chip breaking and chip removal. At the same time, it shall be noted that the tool with higher strength shall be selected as far as possible.
Turning milling compound machining parts
The cutting of wide groove is generally the groove that is larger than the width of a cutter. The width and depth of the wide groove require relatively high precision and surface quality. Roughly cut the wide groove by cutter arrangement. Dongguan CNC Precision Machining Factory
Then use the finishing grooving cutter to cut along one side of the groove to the groove bottom, finish machining the groove bottom to the other side of the groove, and then exit along the side.