In fact, a workpiece to see not only the strength of a manufacturer, but also to see his approach to some details. For cnc cnc lathe machining parts, if the manufacturer is not handled well, then this machining parts are not available, then in processing for manufacturers, should pay attention to what?
First, the price surface burr, it can be said that for this point is a lot of manufacturers are easy to ignore, many people say this part out of what kind of time, that the finished package is what kind of time. In fact, otherwise, for a part, cnc cnc lathe machining parts is done through the equipment, then injection molding will produce cloak, and this burr is also generated at this time, if not timely trimming, or will be this part scrap. Otherwise will be in use will also affect the other links.
Second, the accuracy of the parts, for cnc cnc lathe machining parts, her accuracy is very strict, only to meet the required accuracy, can be used, and judge it this accuracy, mainly to see his ability to control the size, if the tolerance can fluctuate within the provisions, then this part is qualified, if beyond the tolerance, then it is not qualified.
Third, the analysis of the test results, for a component, he will inevitably go through a performance test before leaving the factory, if the performance is qualified, then it will be factory, if not, then some of the reasons should be analyzed, so as to avoid the scrapping of large quantities, processing industry manufacturers will basically be so to deal with, they will be based on some of the performance of many homes, will Make a certain quality control chart, so as to analyze the causes.
Your message must be between 20-3,000 characters!
